Emu Black hardware revisison clear up

Support for EMU BLACK device
Post Reply
hIGGI
Posts: 8
Joined: Fri Dec 02, 2016 9:15 pm

Emu Black hardware revisison clear up

Post by hIGGI » Tue Jul 18, 2017 9:23 am

Hi

I have C revision of black from Karel and would like to confirm my pinout before doing some changes.

I would like to confirm that in my revision
- there are flyback diodes on AUX1 a AUX2
- there is no AUX4 pullup to 12V
- there is no CAN BUS terminator (which has been added in rev. D?)

and most importantly, i dont know whats on pin B38, since sensor ground has been added there in revision D

thanks

hIGGI

hIGGI
Posts: 8
Joined: Fri Dec 02, 2016 9:15 pm

Re: Emu Black hardware revisison clear up

Post by hIGGI » Wed Jul 19, 2017 3:32 pm

anyone?

Jean Niemi
Posts: 121
Joined: Sat Aug 16, 2014 7:05 am
Location: Finland
Contact:

Re: Emu Black hardware revisison clear up

Post by Jean Niemi » Thu Jul 20, 2017 6:41 am

In revision C
- there are flyback diodes on AUX1 and AUX2
- there is no AUX4 pullup to 12V
- there is no CAN BUS terminator
- pin B38 is not sensor ground, do not connect.

hIGGI
Posts: 8
Joined: Fri Dec 02, 2016 9:15 pm

Re: Emu Black hardware revisison clear up

Post by hIGGI » Thu Jul 20, 2017 7:21 am

so, there is nothing on B38 pin at all?

Post Reply
stół kuchenny okrągły

Who is online

Users browsing this forum: No registered users and 1 guest