Need sensor definition file for my AFM signsl

DET3 technical support
Post Reply
spddm0n
Posts: 21
Joined: Wed Dec 09, 2015 9:13 pm

Need sensor definition file for my AFM signsl

Post by spddm0n » Mon Sep 24, 2018 7:08 am

Strangely, my AFM signal outputs 5V when it’s closed, and 0V when it’s open. Backwards from most. The sensor input on the fuel table reads 0-5V, and this makes it very difficult to manage with my AFM signal output. Is there a way to rewrite the liner sensor definition file to account for a 5V to 0V (decreasing), rather than a 0-5V (increasing) response? I looked at the text in the definition file, but I’m not familiar with the basic language this file type uses. Anybody know how I might rewrite it to account for decreasing linear voltage Berwyn 5-0V?

Thanks!!!

Post Reply
stół kuchenny okrągły

Who is online

Users browsing this forum: No registered users and 1 guest