Fuel Table: Modify vs Load

DET3 technical support
Post Reply
spddm0n
Posts: 21
Joined: Wed Dec 09, 2015 9:13 pm

Fuel Table: Modify vs Load

Post by spddm0n » Mon Sep 24, 2018 7:02 am

I don’t fully understand how these two functions work. If I set the “Modify” attribute to my AFM output signal (Analog Input #1), the engine will run just fine. I don’t understand why this works for the “Modify” attribute, and not “Load”. What is the difference between Modify and Load? I don’t understand the explanation in the manual. :)

Thanks!!!

Post Reply
stół kuchenny okrągły

Who is online

Users browsing this forum: No registered users and 1 guest